Maximum continuous current: 120A (at 23°C), 100A (at 85°C)
 Capable of interrupting 120A current
Dual-group contacts in parallel configuration reduce contact voltage drop
Plastic-encapsulated design achieves IP6K7 protection rating in initial state
Coil holding voltage applied to entire unit reduces power loss
Meets IEC 61000-4-5:2017 surge current requirement of 5000A (8/20μs)
Suitable for wave soldering conditions
1. Coil voltage type: DC
2. Coil operating voltage: 24V
3. Contact configuration: One set normally open
4. Number of contacts: Single contact
5. Lead type: PCB-mount
6. Mounting type: PCB mounting
7. Package type: Plastic-encapsulated
8. Lead structure: Standard pin width, short leads (2.25mm)
9. Coil power rating: Standard
10. Coil characteristic: Monostable
11. Contact material: AgSnO₂
12. Packaging: Blister pack
13. Load voltage: 12V
14. Rated Coil Power: Approx. 1.5W
15. Dielectric Withstand Voltage: 600VAC 1min
16. Operating Time: ≤15ms
17. Release Time: ≤7ms
18. Creepage Distance: 6mm
19. Clearance Distance: 0.45mm
20. Insulation Resistance: 100MΩ
21. Maximum rated switching current (DC): 120
22. Maximum switching voltage (DC): 14
23. Temperature range: -40°C to 85°C
24. Mechanical endurance: 10,000,000 cycles
25. Electrical endurance: 100,000 cycles
26. Contact Gap: 0.45mm
27. Application Fields: Power Management Systems, Rear Window Defoggers, Battery Disconnect Devices, Automotive Air Conditioning, Fog Light/Headlight Control, Fuel Pump Control, Anti-lock Braking Systems (ABS), Traction Control Systems, Cooling Fan Control
28. Weight: Approx. 35g
29. Volume: 17161mm³