Snow Plow Pump Motor for Fisher Western MVP HD XLS 12V 1.2kW CW Replaces MUE6302 W-6306 Lester 10779

Blade won't lift. Or it lifts halfway and quits. You cycle the controller a few times, it groans, then nothing at all. On a Fisher or Western plow that usually means one thing: the pump motor has had it.

This is the swap-in replacement. 12 volts. Clockwise. 1.2kW, which is about 1.61 horsepower, enough to run the pump under full load with a wet blade hanging off the front. Four field coils inside, copper windings, fully insulated ground. The field housing measures 114.1mm across, overall length 179.4mm, and the shaft is a 16mm slotted end that couples straight to the pump drive.

Numbers it covers: MUE6302. MUE6302S. MUE6306. MUE6306S. MUE6306A. W-6306. Lester 10779. Arrowhead LPL0059. Haldex-Barnes 220-1115. Also Alltech 105-10779, Mondial 70-648-41, Nastra WSP-1, PASCO S-700844A. Stamped on the old motor or listed in the parts book, any of these means you're looking at the right unit. It fits Fisher MVP, HD and XLS plows and the matching Western pumps.

One thing to know before it arrives. This motor ships without the drive end plate. Yours has one, bolted to the pump. Take it off the old motor, move it to this one, done. The thru bolts sit at the 3 and 9 o'clock positions. If your old unit has them at 12 and 6, stop, that's a different variant. Terminals are dual 5/16-18 posts, so the factory cables land right where they were.

Hookup takes minutes. Battery cable to one post, controller wire to the other. Nothing to splice. Cycle the joystick and the blade should snap up like it did when the truck was new.

Why buy this over the counter unit? The original lists somewhere between $135 and $200 depending on where you ask. This is a brand new motor, not a reman with someone else's worn brushes inside. Sealed housing, so slush and road salt stay out of the works. Built in an ISO 9001 and IATF 16949 certified plant, CE marked, twelve months of warranty behind it.

In the box: motor x1. Drive end plate and mounting bolts come off your original unit and get reused.