1 years
China
Fits:
Arctic Cat Wildcat 1000 2014-2015, Wildcat 1000 Late build 2013, Wildcat 4 2013-2014, Wildcat 4 LTD 2014, Wildcat 4X 2014-2016, Wildcat 4X LTD 2014-2018, Wildcat GT 2013, Wildcat LTD 2013-2014, Wildcat LTD Late Build 2013, Wildcat Sport 2015-2016, Wildcat Sport LTD 2015-2018, Wildcat Sport SE 2017, Wildcat Sport XT 2015-2018, Wildcat Trail 2014-2018, Wildcat Trail LTD 2015-2018, Wildcat Trail SE 2016-2017, Wildcat Trail XT 2014-2018, Wildcat X 2013-2016, Wildcat X EPS 2018
Bearing Material: Heat-treated 52100 chrome steel for high load capacity and resistance to impact wear on rough off-road terrain Seal Design: Dual-lip nitrile rubber seals to block mud, water, and dust intrusion while retaining internal lubrication Included Components: Pre-lubricated center bearing, rubber vibration isolator mount, powder-coated steel support bracket, zinc-plated mounting hardware, and step-by-step installation guide Mount Durometer Rating: 60A durometer rubber isolator to balance vibration dampening and driveline stability under hard acceleration and load Operating Temperature Range: Rated for continuous use between -40°F and 320°F to perform in extreme cold, high-heat desert, and humid trail environments OEM Interchange: Direct factory replacement for Arctic Cat OEM part numbers 1402-052 and superseded part number 1402-293 Shaft Compatibility: Fits all stock and aftermarket 25mm (1-inch) diameter main driveshafts on listed Wildcat models Load Rating: 14.0 kN static load capacity, 14.8 kN dynamic load capacity to support driveshaft weight and absorb shock loads from jumps, ruts, and rough trail surfaces Pre-Applied Lubrication: Factory-packed with high-performance EP2 lithium complex grease fortified with anti-corrosion and anti-wear additives Installation Torque Specification: Mounting bracket bolts require 32 ft-lbs of torque; bearing retaining set screws require 15 ft-lbs of torque for secure, slip-free hold Warranty: 1-year limited warranty against defects in materials and workmanship for recreational off-road use Corrosion Resistance: Powder-coated bracket and zinc-plated hardware withstand 500+ hours of salt spray testing to resist rust from mud, road salt, and trail moisture Service Interval: Bearing inspection recommended every 1,000 riding miles; re-grease every 2,000 miles with EP2 wheel bearing grease for extended service life